Bosch MX938I 사용자 설명서

IMPORTANT

Before walk testing, the system should be fully wired,
powered, and programmed.

• Configure LED Configuration Switch (S1) to LED ON.

•

Replace the front cover.

All testing must be performed with the
front cover in place.

• Wait at least 2 minutes (with no motion in the

coverage area) for the detector to setup.

• Walk test across the coverage pattern.

• The edge of the coverage is determined by

activation of the LED.

• Walk test the unit from both directions to determine the

boundaries.

IMPORTANT

On 2-wire systems, configure the LED to OFF when
finished with walk tests.

• The range and coverage should be checked in accordance with

the Walk Testing section (6.0) on a regular basis.

• Consult the Control Panel’s User's Guide for the procedure on

performing a zone test.  Performing a zone test on a regular
basis assures an alarm output prior to arming the system.

• Excessive handling of the mirror surfaces may lead to

performance degradation.

• Refer to the mirror module and pattern drawings for masking

information.

• Before masking, be sure the chosen mirror surface is the correct

one. When removing masking, remember, many adhesives will
either destroy the mirror’s surface or leave residue behind to
reduce coverage performance.

(Cross Section of 2 Opposite Zones)

(Cross Section of 2 Opposite Zones)

© 2004 Bosch Security Systems
130 Perinton Parkway, Fairport, New York, USA 14450-9199
Customer Service: (800) 289-0096; Technical Support: (888) 886-6189

03/04

MX938i Installation Instructions

P/N: 45988F     Page 4