Wacom Intuos 사용자 설명서
Page 42
SETTING RIGHT- OR LEFT-HANDED OPERATION
The 4D Mouse can be set for either right- or left-handed use. Set the mouse so that the thumbwheel is
exposed on the side next to your thumb—the button settings will automatically be reconfigured. The
default setting is for the click button to be under your index finger. Refer to
exposed on the side next to your thumb—the button settings will automatically be reconfigured. The
default setting is for the click button to be under your index finger. Refer to
.
Pull up.
Then move over.
Snap into position.
Handling edges
To change the handedness configuration:
1
2
3
4
4
Grasp the upper portion of the 4D Mouse in one hand and face the bottom portion toward you. Viewed from the
bottom, a thumbwheel is visible at both sides of the body. A pair of handling edges are on the left and right, below
the thumbwheel.
bottom, a thumbwheel is visible at both sides of the body. A pair of handling edges are on the left and right, below
the thumbwheel.
With your other hand, grasp the lower portion of the 4D Mouse by the handling edges. Carefully pull the two halves
slightly apart (about 5 mm, or 1/4 of an inch).
slightly apart (about 5 mm, or 1/4 of an inch).
Rock the lower portion of the 4D Mouse to the other side so that the opposite thumbwheel is exposed.
Relax your grip, allowing the halves to pull back together. You may need to gently press the two halves so they will
properly seat. When repositioned, the 4D Mouse will mirror its initial state.
properly seat. When repositioned, the 4D Mouse will mirror its initial state.