Wacom Graphire - 2 for Macintosh 사용자 설명서

     Page  84

From the Wacom control panel’s H

ELP

 menu, select D

IAGNOSTICS

... to open the D

IAGNOSTICS

 dialog box.  

The tablet driver version, tablet hardware and connection, and pointing device information is shown.

1. While observing the P

OINTING

 D

EVICE

 I

NFO

 column, bring your Graphire2 Pen within proximity of the 

tablet.  A value for proximity, the device name, and device type should be displayed.

2. Move the pen along the tablet surface. The X and Y D

ATA

 values should change to reflect the tool 

position.

3. Test your Graphire2 Pen buttons.  The tablet’s status LED should change color from orange to green 

each time you click with the pen tip, press the side switch, or press the pen’s eraser to the tablet.
•

Click on the tablet surface with the pen tip—the S

WITCHES

 state and P

RESSURE

 value should 

change.  (P

RESSURE

 should change from approximately 0% with no pressure applied to 

approximately 100% when full pressure is applied.)

•

Next, press the side switch without pressing the tip to the tablet—the S

WITCHES

 state should 

change.  (Do this for both positions of the DuoSwitch.)

•

Then press the pen’s eraser to the tablet—the S

WITCHES

 state and P

RESSURE

 value will change.    

(P

RESSURE

 should change from approximately 0% with no pressure applied to approximately 100% 

when full pressure is applied.)

4. When you are done, click on the C

LOSE

 button to exit the dialog box.

Tip = Tip,   DuoSwitch (lower position) = b1,   DuoSwitch (upper position) = b2,   Eraser = Eraser