Watts Radiant WQC4 RO 사용자 설명서

Position tank in desired location.  Stand it upright or lay it  on its 
side (using the black plastic stand).  Measure the white tube from 
the RO module port  marked TANK  over to the tank and cut it to 
desired length.

Insert the white 1/4” tube through tank valve compression nut.  
Place 1/4” plastic insert in tubing.  Push tubing into valve.  Hand 
tighten the compression nut securely, and add 1/4 turn with a 
wrench.

Step 22

Step 19

Step 21

Step 20

Remove a brass nut, plastic  sleeve and brass insert from the parts 
bag.  Place nut on  the tube fi rst, then the sleeve (Small taper end 
of sleeve must point to the end of tube) and then insert the brass 
insert into the end of the tube. 

Insert the white tube into the ¼” opening on the adapta valve until 
it stops.  Slide  nut and sleeve down and thread onto the male pipe 
threads.  Use a ½” wrench to securely tighten.  Run the tube to 
the inlet on the back of the RO system.  Leave enough tube so it 
is not kinked and cut the tube to desired length.