Wacom GRAPHIRE 4 사용자 설명서

37

37

Double-clicking is difficult.

Be sure you are quickly tapping the tablet twice in the same place on the 
tablet active area.

Using a side switch to double-click is recommended (review the 
techniques in 

Set one of the tablet ExpressKeys to D

OUBLE

 C

LICK

 and use it to issue 

double-clicks.

See 

•

Try increasing the D

OUBLE

-C

LICK

 D

ISTANCE

.

•

Try using a lighter T

IP

 F

EEL

.

Windows: Try setting your system to launch programs with a single 
click.  See 

.

The pen selects everything, 
will not stop drawing.

Open the Pen Tablet control panel and go to the P

EN

 tab.  Move the T

IP

 

F

EEL

 slider toward F

IRM

.  If this does not help, see 

The eraser selects everything 
or will not stop erasing.

Open the Pen Tablet control panel and go to the P

EN

 tab.  Move the 

E

RASER

 F

EEL

 slider toward F

IRM

.  If this does not help, see 

You notice a screen delay at 
the beginning of pen strokes.

Try decreasing the D

OUBLE

-C

LICK

 D

ISTANCE

 (see 

You have to press hard with 
the pen when clicking or 
drawing.

Open the Pen Tablet control panel and go to the Pen tab.  Move the T

IP

 

F

EEL

 slider toward S

OFT

.

The pen tip does not function.

Make sure the tablet status LED changes from blue to green when the 
pen tip is pressed to the tablet surface.  If it does not, you may have 
defective hardware (see 

The upper or lower side switch 
does not work.

Be sure you press the side switch when the pen tip is within 5 mm 
(0.20 inch) of the tablet active area – do this without pressing down on 
the pen tip.

From the Pen Tablet control panel, verify that the side switch is set to the 
function you are expecting to occur.

Make sure the tablet status LED changes from blue to green when you 
press the side switch.  If it does not, you may have defective hardware 
(see 

The screen cursor jumps back.

Do not place the pen or cordless mouse on the tablet when they are not 
in use, or when you are using another pointing device.  Leaving your 
tool on the tablet may interfere with screen cursor positioning when 
using other input devices.