Stanley Black & Decker DS06 사용자 설명서
16
REPLACING THE CHAIN BREAKER
PUNCH
If the chain breaker punch (part number 22801) becomes
worn or damaged, use the following prcedures for replace-
ment.
worn or damaged, use the following prcedures for replace-
ment.
1. Remove the punch by loosening the set screw (Figure
15).
15).
Figure 15. Removing the Punch
2. Insert a new punch into the holder and push it up until it
is fully seated (Figure 16). Secure the punch to the chain
breaker holder by fully tightening the set screw.
is fully seated (Figure 16). Secure the punch to the chain
breaker holder by fully tightening the set screw.
Figure 16. Replacing the Punch
SPINNING RIVETS
The following procedures explain how to spin rivets using
Stanley’s bench-mounted rivet spinner (part number 20857)
to assembly the chain.
Stanley’s bench-mounted rivet spinner (part number 20857)
to assembly the chain.
1. Mount the rivet spinner fl ush with the side or front of a
fl at, clean work surface (Figure 17).
fl at, clean work surface (Figure 17).
Figure 17. Rivet Spinner Mounting
2. Lay the chain across the plastic chain supports and then
rotate the supports so the rivet head is centered between
the take-up handle pocket and the spinner anvil (Figure
18).
rotate the supports so the rivet head is centered between
the take-up handle pocket and the spinner anvil (Figure
18).
Figure 18. Positioning the Chain
3. Turn the take-up handle until the chain is tight against
the spinner anvil (Figure 19).
the spinner anvil (Figure 19).
Figure 19. Securing the Chain
MAINTENANCE & ADJUSTMENTS
Rivet Spinner
Crank
Crank
Take-up
Handle