Sony Water Dispenser 2 사용자 설명서

199

Setup for the Whole System

  

Ch
apt

er 16 

E

ngin

eering Se

tup

In the <Active Line> group, select the number of active scan lines.

Use the following procedure.

In the System>Format>Active Line/Aspect menu, select one of the 
following from the <Screen Aspect> group.

• 16:9
• 4:3
• Independ

Set the screen aspect ratio separately for M/E, P/P, and USER on the 
switcher, and for each channel independently on the DME.

If you selected [Independ] in step 

, select from the following.

Switcher Aspect: Make the setting for the switcher.
DME Aspect: Make the setting for the DME.

A menu appears according to the selection.

Carry out either of the following, depending on the selection you made in 
step 

.

When you selected [Switcher Aspect]: In each of the <M/E-1>, <M/E-

2>, <M/E-3>, <P/P>, and <USER> groups, select either [16:9] or 
[4:3].

When you selected [DME Aspect]: For each of the <CH1> to <CH4> 

groups, select either [16:9] or [4:3].

To set the initial state at start-up, use the System>Start Up menu.

It is not possible to set the DCU state at start-up, but its settings can be saved 
in the control panel.

In the Engineering Setup menu, select VF1 ‘System’ and HF4 ‘Start Up.’
The status area shows the current start-up mode settings.