Ronco Electric Pasta Maker 지침 매뉴얼
11
The device has a safety switch. This is located inside the motor unit
and is activated by a pin on the mixing container lid. The device can only
be switch on using the On/Off switch if the mixing container lid is placed on
correctly and the pin activates the safety switch!
be switch on using the On/Off switch if the mixing container lid is placed on
correctly and the pin activates the safety switch!
If the device won’t turn on, push the front of the bin and double check the lid
to make sure it is snapped in place and secured.
to make sure it is snapped in place and secured.
Using the Pasta Maker
CAUTION
!
• Only connect the device to a socket that is properly installed, is easily
accessible and corresponds to the technical data of the device.
• Always assemble the device in full before you plug it in.
• The device has a safety switch. It is located inside the motor unit and
• The device has a safety switch. It is located inside the motor unit and
is activated by a pin on the mixing container lid. The device can only
be switched on using the On/Off switch if the mixing container lid is
placed on correctly and the pin activates the safety switch. If the pin
on the mixing container lid is damaged, do not attempt to activate the
safety switch or bypass/repair it using your own hands. In the event of a
defect, contact the customer service department. Stop using the device
until it has been repaired.
be switched on using the On/Off switch if the mixing container lid is
placed on correctly and the pin activates the safety switch. If the pin
on the mixing container lid is damaged, do not attempt to activate the
safety switch or bypass/repair it using your own hands. In the event of a
defect, contact the customer service department. Stop using the device
until it has been repaired.
• Make sure that the On/Off switch is in the OFF position before you
connect the device to the mains power.
• Do not overfill the mixing container! Excessively large quantities of
ingredients may cause damage to the device. Larger quantities should
be spread between two or more kneading operations. While you can mix
up to 3 cups of flour, we recommend doing 2 cups at a time.
be spread between two or more kneading operations. While you can mix
up to 3 cups of flour, we recommend doing 2 cups at a time.
• Do not operate the device for more than 15 minutes without interruption!
Operating the device continuously for too long may cause damage to
the device. Switch the device off after 15 minutes and let it cool down
for a few minutes before you switch it back on again.
the device. Switch the device off after 15 minutes and let it cool down
for a few minutes before you switch it back on again.
• If dough gets stuck during kneading or the kneading spiral does not
rotate evenly, never attempt to reach through the slot-shaped openings