Ronco Electric Pasta Maker 지침 매뉴얼

28

 

•  Remove the plug from the mains socket before cleaning the device.
•  Never immerse the motor unit in water or other liquids!
•  Do not use corrosive or abrasive cleaning agents to clean the device. 

These could damage the surface.

 

The plastic parts (mixing container or kneading spiral) may become 

discolored as a result of the addition of certain ingredients (e.g. vegetable 
juices containing a lot of coloring agent). However, this is harmless and will 
not have any adverse impact on the flavor of your pasta. The discolouration 
of plastic parts by ingredients containing a lot of coloring agent does not 
constitute grounds for a complaint.

Dismantle the device each time before you clean it so that you can clean 
all accessories with warm water. If necessary, allow stubborn remnants of 
dough to soften for a little while in warm water:

1.  Unscrew the locking ring.
2.  Remove the pasta attachment.
3.  Open the lid by pressing together the locking clip and pulling the lid up 

at the same time. Remove the lid.

4.  Disengage the connecting piece by turning it counter-clockwise (in the 

opposite direction to the arrow marked on the mixing container).

5.  Pull the face plate together with the dough screw conveyor and the 

kneading spiral out of the mixing container.

6.  Remove the kneading spiral from the drive shaft of the dough screw 

conveyor.

7.  Remove the connecting piece from the dough screw conveyor.
8.  Take the mixing container off the motor unit.