Chamberlain Remote Light Switch 사용자 설명서

If the light does not operate, below are some troubleshooting 
suggestions.

The light does not 
operate from the 
switch.

•   Verify the power is ON. Check the fuse box or 

circuit breaker.

•   Verify the light bulb is “good”.

•   Press the top half of the remote light switch 

to make sure it is ON.

•  Ensure the device is properly grounded.

•   Verify the electrical Line and Load wiring is 

correct. If you are unsure which wires are 
Line and Load, reverse the Line and Load 
wire connections.

The light does not 
operate from the 
remote control.

•   Make sure you are pressing the remote 

control button selected to operate the light 
control.

•   The LED on the remote control should glow 

when the button is pressed, if not replace the 
battery.

•   Program the remote control to the remote 

light switch.

The LED flashes for 
more than 10 
minutes and cannot 
enter the 
programming 
mode.

•   This indicates an issue with low voltage or 

improper grounding. Ensure the device is 
properly grounded. Contact a qualified 
electrician.

To avoid electric shock, press the switch to the OFF position when 
changing the light bulb.

Press and HOLD the “LEARN” button until the LED flashes 
(approximately 6 seconds). All codes are now erased. 

4