Znyx Networks NETBLASTER ZX410 사용자 설명서

Page 4 

ZNYX

ZNYX

ZNYX

ZNYX NetBlaster ZX410 Series User’s Guide    

Hardware Installation 

Below are the steps necessary to install a NetBlaster CompactPCI adapter into a standard, 

compliant system. In most systems, the configuration is “plug and play”, which requires no 

operations on the part of the installer. The following are detailed instructions for the hardware 

installation procedure. 

This installation procedure is for installing an adapter into standard, compliant systems. Some 

steps in this procedure may vary depending on the specific system used. Refer to the system’s 

documentation if necessary. 
 

The figure on the following page shows the installation of an adapter in a typical system.  

 

1.  Turn off your system. 

 

2.  Discharge any static electricity from your body by touching the metal case, or by using an 

anti-static wrist strap. If you do not have a ground strap, maintain physical contact with the 

case to maintain the same electrical potential with the system. 

3.  Select an available CompactPCI slot. 

 

4.  Remove the slot cover from the front panel slot filler bracket. 

 

5.  Insert the ZNYX adapter into the slot. Make certain that you push the adapter straight 

into the slot; the bracket and the slot must be properly aligned and the adapter fully 

“seated”. A good “seat” is when the bracket touches the system case, up to the extraction 
levers. 

 

6.  Pull up on the extraction levers to finish seating the adapter. 

 

7.  Secure the retaining screws. 

The LAN cable must be properly attached to a functioning network for the adapter to operate. 

100 Mbps connections require Category 5 cabling.