VIVOTEK Vivotek Automobile Electronics vc8201 사용자 설명서

 

 

Drill a hole on ceiling or wall. The diameters for the installations with or without the 

retention tube are different.

50mm

45mm

1. Detach the top cover.

2. Install the retention tube. 

3. Route the sensor cable through the hole, and then connect to the lens module.  

Use the M3 self tapping screws if installed without the retention tube. Note that this type of 

installation does not apply to hard surfaces, such as a concrete wall. 

w/ the retention tube

w/o the retention tube