VIVOTEK NR7401 사용자 설명서

 

 

 

 

Reboot

: Press and release the indented reset button� All status LED will extinguish and then 

power on again. Wait for the Status LED to blink and then become steady green in normal state. 

It takes about 30 seconds to complete the procedure�

Restore

: Press the reset button continuously for over 3 seconds� All status LED will extinguish 

and then power on again. Wait for the Status LED to blink and then become steady green in 

normal state� Note that all settings will be restored to factory default� It takes about 50 seconds 

to complete the procedure�

Before using the Network Video Recorder, the first step is to install a 

SATA hard disk for re-

corded video� Please follow the steps below:

1� Make sure the power is off�

2. Use a screwdriver to loose five screws, and then slide to remove the upper cover.

3� Loose the screw and take out the hard disk bracket�

4� Put your hard disk into the bracket, and secure it with the supplied four screws�

5� Place your hard disk into the Network Video Recorder�

6� Slide the hard disk as the picture shows, and then secure it with the original screw�

7. Attach the upper cover, and then secure it with the original five screws.

► Please remember to format the hard disk 

before strating recording� Please refer to 

Power POE Status HDD WAN LAN1 LAN2 LAN3 LAN4

NR7401 Network Video Recorder

Steady green in normal state