Viper 3105V 사용자 매뉴얼

13

© 2012 Directed. All rights reserved.

Panic mode

If you are threatened in or near your vehicle, you can attract attention 
by triggering the system with your remote.

Press 

 for approximately two seconds, to enter Panic  Mode. The 

siren sounds and the parking lights flash for the programmed siren 
duration. To stop Panic Mode at any time, press the 

. 

Valet mode

You can prevent your security system from automatically arming and 
trig ger ing by using Valet Mode. This is very useful when washing the 
ve hi cle or having it serviced. In Valet Mode, the security system will 
not arm, even with the remote trans mit ter, but all convenience functions 
(door locks, trunk re lease, etc.) will continue to work nor mal ly.

To enter or exit Valet Mode: 
1.  Turn the ignition on. 
2.  Turn the ignition off.
3.  Press and release the Valet switch within 10 seconds.

The status LED lights solidly if you are en ter ing Valet Mode, and goes 
out if you are exiting Valet Mode.

To enter or exit Valet Mode with the remote:
Open any vehicle door, and then quickly press the following buttons 
in the sequence indicated. 
4. Press  .
5. Press 

 and then press 

 again. The in - vehicle status LED 

lights solidly if you are entering Valet Mode, and goes out if you 
are exiting Valet Mode.