Videk VISIONSENSOR 2030 사용자 설명서

K11020 VisionSensor™ 2030 User Manual, Rev. E, Software ver. 3.1.1000, August 3, 2007    -    

.5. - Introduction
Batch data storage and data transfer are controlled by the resident JavaScript application on your VS 2030 

reader.  Under the default factory settings, batch mode is enabled.  

When the VS 2030 is NOT connected to a host PC or other device, it will store reading data.  Then when 

subsequently connected to a host device the VS 2030 will automatically upload all of the read data and 

erase it from its memory.  

MAKE SURE that when the VS 2030 is connected to the host device that the appropriate application is 

open and active on the host device.  If not, the read data will be lost.  
  
 
.5.2 - RS232 Considerations

In RS232 Batch Cable-Detect mode, the VS 2030 will detect if it is connected to a powered serial cable, 
and will send the data.  If a powered serial cable is not connected or if the power adapter is not connected 
to the serial cable, the VS 2030 will buffer the data.  When the VS 2030 is then connected to a powered 
serial cable, the data will automatically upload and be erased from the VS 2030 memory.

In RS232 Cabled - No Power mode, the VS 2030 will behave as if it is always connected even though the 
serial cable is disconnected or the power adapter is unplugged. Scanned data will be sent, regardless of 
connection status.  Data scanned in Cabled mode will be lost if the VS 2030 is not connected to the serial 
cable.  It will not buffer the data, unless Send & Store mode has been enabled.

Important Note: If you are in RS232 Cabled-No Power mode, when you place a unit in a charger the 

reader will behave as if it is being cabled, and download the data.  THE DATA WILL BE ERASED FROM 
MEMORY. To disable this feature, scan the RS232 Cable - Detect code.