Videk VISIONSENSOR 2030 사용자 설명서

K11020 VisionSensor™ 2030 User Manual, Rev. E, Software ver. 3.1.1000, August 3, 2007    -    

To read a symbol with the VS 2030:
         

1. The VS 2030 features omnidirectional decoding.  Center the symbol in any orientation within the laser 

dot aiming pattern. 

 
 

  Note: The VS 2030 can read a symbol that is not centered; however, the VS 2030 performs best 

when a code is centered.  If two (2) bar codes are with the imagers decode zone, the VS 2030 will 
decode the symbol closest to the center of the aiming dot.

         
2. The VS 2030 was developed to decode both very small 2-dimensional symbols and larger 1-dimen-

sional symbols.  The unit has an innovative dual field decode zone.  The VS 2030 

ZONES SIMULTANEOUSLY.  The unit has a lens focused on a near-field for smaller codes (optimal 

focal point is 4 inches) and one lens focused on a far-field for larger codes (optimal focal point 9 
inches). To read smaller symbols move the VS 2030 closer to the symbol.  To read larger symbols 
move the unit farther away from the symbol.  The entire VS 2030 decode zone varies between two 
(2”) and  twenty (20+”) or more inches.  

3. Hold the VS 2030 steady - 

DO NOT SWIPE OR MOVE THE READER.  Press the trigger until the VS 

2030 beeps, indicating the code has been successfully decoded.

4. The reader may be optimized to your specific environment by scanning codes in Chapter 2.      

The VS 2030 utilizes digital camera technology to take a picture of a symbol.  Once an image is captured, the 
VS 2030 utilizes advanced decoding algorithms to extract data from the captured image. 

The VS 2030 features left and right triggers (the 
red buttons on the top of the reader).  These 
triggers may be programmed to perform various 
features. The reader is shipped with the left trigger 
and right trigger functioning as a decode symbol 
command. 

The handle has a trigger on the grip. The two 
triggers on the top of the unit also work when the 
handle is attached.