Vertek/XTC SCORPION 2330 사용자 설명서

The pulse input connector supplies 12 volts DC to the coin validator and accepts a 
pulse stream from the coin validator. Several adaptor cables are available for 
different coin validators

1

2

3

4

5

12V Fan

12V Lamps

12V Lamps

12V Lamps

1

2

3

This connector supplies a constant +12V output from pin 1 with 4 switched ground 
returns. One for each of the 4 switching channels. These ground returns are open 
collector transistor switches.

Up to 4 groups of low power 12V lights can be connected and will be controlled by 
the light chaser. Output 4 is a special case and may be connected to a 12 V fan. 
Make sure the total current consumption of all the connected lamps etc. does not 
exceed 2.4amps. Shown below is a typical configuration.

Caution: Improper connection may cause damage to the unit.

2K2

MicroCoin

Typical coin validator 
connection for Low
pulses.

Gnd

Acc (Pulse Output)

+12VDC