United States Stove 5660 사용자 설명서
21
INSERT PELLET STOVE INSTALLATION
U.S. Stove Pellet Burning Room Heaters are also available as an insert into existing masonry of factory-built fi replaces. Do
not alter the existing fi replace in any way either by removing bricks and mortar which could weaken the structural integrity of
the fi replace. There is a small amount of assembly required when installing this model. The steps are as follows:
not alter the existing fi replace in any way either by removing bricks and mortar which could weaken the structural integrity of
the fi replace. There is a small amount of assembly required when installing this model. The steps are as follows:
Note: The shroud must be installed before unit is set into its fi nal position.
Step 1: Shroud Side: Facing the back of the unit take the left shroud side piece (no control panel hole) and fasten, as shown,
with 2 screws provided.
with 2 screws provided.
Step 2: Shroud Side: Facing the back of the unit take the right shroud side piece (with control panel hole) and
fasten, as shown, with 2 screws provided.
fasten, as shown, with 2 screws provided.
Figure 16
Screw Here
Screw Here
Figure 17
Screw Here
Screw Here