Uniden BCD996T 사용자 설명서

108

4

J

F

4

 or Off

J

F

This feature sets whether the scanner tries to tune to a repeater output frequency 
during Custom Search, Quick Search, or Close Call operation when it detects a 
transmission on a repeater input frequency. Since you can normally only hear one 
side of a conversation when you listen to an input frequency transmission, turning 
this feature on can let you hear both sides of the conversation where a standard 
difference frequency is set between the input and the output, to and from the 
repeater.

 — The scanner automatically applies repeater reverse to detected 

transmissions. If the scanner detects the transmission on the output frequency, it 
beeps, Repeater Found appears, and it remains on the output frequency until 
transmissions end. If it does not detect a transmission on the output frequency, it 
remains on the original frequency.

 — The scanner does not try to find the output frequency.

J 4

J

F

4

J

F

This value sets how many hits the scanner will automatically store when it is in 
either Search and Store or Close Call Auto Store mode. Use the number keys to 
enter a value from 1 - 256, then press 

F

. The default value is 100.

When the scanner exceeds the maximum number of hits you set, it stops the 
auto-store operation.

This setting controls the modulation method used to receive frequencies during 
Quick Search and Close Call operations. In most cases, if you leave this set to 
Auto

, the scanner automatically selects the correct modulation type for the system 

you are programming.

J 4

J

F

4

J

F

 — the scanner uses the default modulation for the frequency band. The 

default setting is Auto.