Univex 6753i 사용자 설명서

Model 6753i RP Phone Installation Guide 9

install the power adapter or the PoE inline power supply (optional accessory). 
1. On the top of your phone, connect the Ethernet cable (provided with 

your phone) into the network port marked with 

. 

2. On the PoE power injector, plug the other end of the Ethernet cable into 

the network jack marked as indicated in the following illustration.

3. On the PoE power injector, connect an additional Ethernet cable into the 

network port as indicated in the following illustration.

4. Plug the other end of the Ethernet cable into the network jack on the 

wall.

5. Plug the PoE power injector into a power outlet. 

Note: You should connect the power supply to a surge protector or power bar. All 

Ethernet cables used must be minimum category 5/5e straight-through 

cables, such as the cable provided with your phone.

Turn the phone over and locate the handset jack marked 

j. Insert one 

end of handset cord into the jack until it clicks into place. Then route the 
handset cord through the groove as shown in the illustration below. Attach 
the handset to the other end of the handset cord.

Ethernet
  Cable

Network Jack

(if Inline power provided,
do not install the power adapter)

To Network