Univex 6753i 사용자 설명서

12 Model 6753i RP Phone Installation Guide

The 6753i RP phone has two pre-drilled wall mounting holes on the back of 
the phone. Using the provided wall mount drilling template, locate and 
mark the position for the mounting screws on the wall. Depending on the 
wall type, you may need to use wall anchors. Both the screws and wall 
anchors are included with your phone.
Place the wall mount holes on the phone over the screw heads on the wall 
and pull down to lock the phone in.

Note: You may wish to purchase a short Ethernet cable from a local supplier for a 

wall installation. Also, if 802.3af compliant in-line power is not provided on 
your network, and you are installing the 6753i RP on a wall using a PoE in-
line power injector, you may also wish to use an equivalent flat Ethernet 
cable rather than the one provided.

This card contains the label identification spaces for 6 programmable keys.
1. Remove the clear plastic lens from the top front panel of the telephone 

by gently pressing down on the lens and sliding upward.

2. Place the card into the programmable key card slot on the top front 

panel of the telephone using the indentation of the plastic for alignment.

3. With one hand holding the label card in place, gently slide the clear 

Wall Mount Holes