Sherbourn Technologies 5/5210A 사용자 설명서

Rear panel view of model 7/2100A

amplifier, it is recommended that wherever pos-

sible you use the XLR Input for your connection.

4. Your amplifier includes a 12V DC trigger input

connector to allow for remote integration with your

preamp/control center. If your preamp includes

provision to output 12V DC to remotely turn on

other equipment, you can use a control cable to

connect the preamp to the trigger input of your

amplifier to allow it to automatically turn on when-

ever you turn on your preamp. We recommend

that a shielded coaxial cable be used for this pur-

pose. A removeable plug at the 12V trigger input

Rear panel view of model 5/5210A showing nonfunctional channels in shaded areas

(comes with the amplifier) shall be unplugged and

wired with the 12V in the correct polarity. The in-

put impedance of the 12V input is 2.2k ohms; it

will accept an input voltage from 9V to 12V.

5. It is strongly advised that you only use the power

cords supplied with the amplifier. Never use any

other power cords with a smaller gauge than the

one provided. Do not use an extension cord to in-

stall your amplifier since it could effectively re-

duce the current capacity supplied to the amplifier.