Siemens TRAFFIC CONTROLS TC12 사용자 설명서
TC12 Installation, Commissioning & Maintenance Handbook
2.2.
lowing, additional, cards installed in it.
ink
t needed if processor card has built-in
2.2.
uld normally have
the following, additional, cards installed in it.
• Digi I/O Card
ver Card (IMD) Xem.
2.2.2
the PC; a
The setting up of a 3Com Etherlink 3 card is described below. There are no links
or j
or j
rs on
a configuration program.
Wit
Ether
ed up and at the C: DOS
prompt The TC12 software installation disk should be inserted into the PC’s floppy
driv
driv
the f
p program:
A:\ELNK3\3C5X9CFG.EXE
P
abled
I/O Base Address
0H
Int
Lev
Transceiver type
Auto Select
o : If Plug and Play is enabled, this should be disabled first, the configuration
sav
nd
PC
ot
efo
ny
r s
gs
h
2.2.2
8
lled in the PC. To run the program the TC12 software installation disk should
A:\UM9008\DIAG9008.EXE
e
ration. The arrow
2.4.2 Rack Mount Wall Map PC
A rack mount PC which is to be used for driving the LEDs on a wall map would
normally have the fol
normally have the fol
• Ethernet Card (E
3) (no
therl
Ethernet)
• Digi I/O Card (1 per digital output rack)
2.4.3 Flat Panel Data Transmission PC
A flat panel PC which is to be used for data transmission wo
• Intelligent Modem Dri
.5 3Com Etherlink 3 Ethernet Card Set Up
The Ethernet card (part number 667/7/22609/014) needs a half slot in
ll slot can be used if there are no half slots available.
fu
umpe
the card and the set up is performed using
h the
net card installed in the PC, the PC boot
e and
ollowing command used to run the set u
The set up part of the program to set the parameters listed below to the values
shown:
shown:
lug and Play
Dis
30
30
errupt Request
el
3
Network Driver Optimisation DOS Client
N te
ed a
the
rebo ed b
re a
othe
ettin
are c anged.
.6 UM9008 On-Board Ethernet Set Up
Where the processor card has a built-in Ethernet controller (UM9008) the UM900
configuration and diagnostic utility program should be run before any boards are
configuration and diagnostic utility program should be run before any boards are
sta
in
be inserted into the PC’s floppy drive and the following command used to run the
diagnostic utility program:
be inserted into the PC’s floppy drive and the following command used to run the
diagnostic utility program:
The first screen of the DIAG9008 program shows the current configuration with the
options of Accept and Exit, Diagnostics, or Configuration. To change th
configuration, select Configuration, followed by Modify Configu
options of Accept and Exit, Diagnostics, or Configuration. To change th
configuration, select Configuration, followed by Modify Configu
666/HE/43100/000
Page 14
Issue 9