SAM4S Cash Register ER-5115 사용자 설명서

1.  Place the key marked REG into the control lock and turn to the REG control lock 

position. 

2.  Locate the rewind spindle.   

3.  Locate the printer cover key.  The printer cover key is the smallest key on the key ring.  

Insert this key into the printer cover lock.  Turn the key, and remove the printer cover.   

4.  Locate and install the printer ribbon cartridge (see "Changing the Printer Ribbon 

Cartridge" on page 16). 

5.  As you face the keyboard, notice two plastic trays behind the printer mechanism.  Place 

one of the rolls of printer paper into the tray on the right.  Make sure the paper will 
unwind from the bottom of the roll.  

6.  Fold back approximately 6" of paper and insert the folded end of the tape into the feed 

slot just in front of the paper tray at the rear of the printer.* 

7. Press 

the

 

DETL FEED key on the cash register keyboard until the edge of the paper 

feeds through the printer.  Run 6 - 8 inches of paper through the printer. 

8.  Insert the end of the paper into the slot on the shaft of the rewind spindle, holding the 

spindle with the gear to the right and the shaft to the left.  Wind the spindle several turns 
to be sure the paper will stay on the spindle.  Press the end piece of the rewind spindle 
back onto the left end of the shaft. 

9.  Slide the axle of the rewind spindle (between the gear and the shaft) into the notch of 

the printer housing.  Make sure the gear on the rewind spindle meshes with the gear 
on the printer. 

10. Press the

 

DETL FEED key several more times to make sure the paper moves properly 

through the printer.