Russound ST2 사용자 설명서

17

The tuner is power managed by the CAV6.6 or other
RNET-enabled controller. If the tuner is in standby
mode, any button press of the UNO-LRC1 will bring
the tuner out of standby mode. 

To select a tuner, push 

and choose the source

number preassigned to Tuner 1 or Tuner 2, or use the

numeric source inputs at the bottom of the 

UNO-LRC1. 

Push 

to toggle between AM band and FM band

reception.

Use the Channel 

and 

for manual tuning.

To move quickly through the channels, press and hold

either of the Channel buttons for more than 1.5 sec-

onds. The Select 

and 

can be used in

the same manner. 

To directly select a station, press the three- or four-

digit station frequency (1071 for 107.1, etc.).

European regions use five-digit station frequencies.

The SEEK function is performed by pressing and

releasing the Select 

or 

. To seek higher

frequency station press Select 

, and press 

Select 

for lower frequencies. Select 

tuning

begins at the current frequency, seeks upward and

stops at the next tuned station. Pushing the Select

again continues the SEEK function. Once the

highest frequency is reached, the tuner continues in

SEEK mode at the lowest frequency. 

To scan, press and hold then release 

. The

tuner scans through tuned stations with a 5-second

preview before moving  to the next station. To end

scanning, press 

again.

To select a bank, press and hold 

for bank up

or 

for bank down. The bank’s name will be

temporarily displayed on the UNO-S2.  

Press the 

and 

to scroll through the

memory presets for the selected bank. This proce-

dure will step through all of the presets in the current

bank, then loop back to start at the first one. Only

configured presets will be displayed.

Press the 

button to mute/unmute the tuner

audio output.