Revolabs Stereo Receiver HDX 9001 사용자 설명서
Revolabs Single Channel System - Polycom HDX 9001/9002 Setup Guide
N
OTES AND
C
AUTIONS
:
This setup guide will guide you through the steps needed to properly connect a
Revolabs Single Channel System to a Polycom HDX 9001/9002 video codec.
1. Connecting the Cables
2. Configuring the HDX 9001/9002 Video Codec
Note:
It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Single-Channel System
2. Revolabs 2.5mm to RCA Audio Cable (included with Single -Channel)
3. Polycom HDX 9001/9002 video codec
4. Polycom Audio Adapter Cable (P/N 2457-23492-001) or equivalent*
2. Revolabs 2.5mm to RCA Audio Cable (included with Single -Channel)
3. Polycom HDX 9001/9002 video codec
4. Polycom Audio Adapter Cable (P/N 2457-23492-001) or equivalent*
*P
OLYCOM
HDX
9000
SERIES VIDEO CODECS HAVE PHOENIX CONNECTORS FOR AUDIO INPUT
/
OUTPUT WHILE
R
EVOLABS
F
USION PRODUCTS USE
RCA
CONNECTORS FOR AUDIO INPUT
/
OUTPUT
.
T
HE
P
OLYCOM AUDIO ADAPTER CABLE CONVERTS
TWO PHOENIX CONNECTORS INTO FEMALE
RCA
CONNECTORS
.
O
THERWISE
,
A TECHNICIAN COULD SIMPLY CUT OFF THE
ENDS OF THE
RCA
CABLES AND CONNECT PER THE DIAGRAM ON THE FOLLOWING PAGE
: