Radio Shack 49-1003 전단

This product is warranted by RadioShack against manufacturing defects in 
material and workmanship under normal use for ninety (90) days from the date 
of purchase from RadioShack company-owned stores and authorized RadioShack 
franchisees and dealers. For complete warranty details and exclusions, check with 
your local RadioShack store.

RadioShack Customer Relations
200 Taylor Street, 6th Floor, Fort Worth, TX 76102

04/04

©2004. RadioShack Corporation. 
All rights reserved. RadioShack and 
RadioShack.com are trademarks 
used by RadioShack Corporation.

 

49-1003

07A04 

Printed in China

Mount the motion detector so it points 

slightly downward to obtain maximum 

coverage. 

1. Attach the motion detector to the 

mounting bracket using the supplied 
machine screw.

2. Use the supplied mounting screws to 

mount the motion detector (with bracket) 

on a wall, about 5 - 6 feet high.

3. Slide 1/2 on the back of the motion 

detector to 1 for instant triggering and 
maximum sensitivity, or to 2 to trigger 
the alarm only after two movements are 
sensed in the coverage area.

This equipment has been tested and found to comply 

with the limits for a Class B digital device, pursuant 

to Part 15 of the FCC Rules. These limits are designed 

to provide reasonable protection against harmful 

interference in a residential installation. This equipment 

generates, uses, and can radiate radio frequency energy 

and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio 

communications. 

However, there is no guarantee that interference will 

not occur in a particular installation. If this equipment 

does cause harmful interference to radio or television 

reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to 

correct the interference by one or more of the following 

measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and 

receiver. 

• Consult your local RadioShack store or an experienced 

radio/TV technician for help.

• If you cannot eliminate the interference, the FCC 

requires that you stop using your motion detector. 

• Changes or modifications not expressly approved 

by RadioShack may cause interference and void the 

user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. 

Operation is subject to the following two conditions: 

(1) this device may not cause harmful interference, and 

(2) this device must accept any interference received, 

including interference that may cause undesired 

operation.

1. Slide 1/2 to 1.
2. Press and hold down TEST until the 

motion detector’s LED flashes twice, 

and then release it.

3. Wait 20 seconds, and then walk in front 

of the motion detector. Its LED lights 

when movement is sensed. If necessary, 

reposition the motion detector for the 

desired coverage area.

4. Press TEST when you are finished. 



