Proxim AP-4000 사용자 설명서

Hardware Installation

2. Attach one end of an Ethernet cable to the AP's LAN port (the center port, labeled “LAN”) and the other end to a 

network hub or switch.

3. Optionally, connect an RS-232 cable to the RS-232 console port (the right port, labeled “RS-232”). 

4. Verify LED Status
5. When the AP-4000/4000M/4900M boots, it performs a series of self-tests.
6. Wait for the power LED to turn green before proceeding.

You can optionally install a security cover to deter unauthorized access to the AP-4000. The security cover is a plastic 
cover that prevents access to the cabling and to the Reset and Reload buttons.

1. Slide the hinging end of the security cover into the hole on the rear panel of the AP-4000/4000M/4900M to the left of 

the connectors.

2. Use two screws to screw the right side of the security cover to the RS-232 screw holes on the rear panel of the 

AP-4000.

Proxim recommends that you have a site survey professionally conducted to determine the best location for the AP. For 
professional site surveyors, Ekahau Site Survey software is included in the Xtras folder on the Installation CD-ROM. 

The following considerations must be kept in mind when the AP-4900M is mounted in a vehicle or outdoors:

• The AP must be protected from exposure, and the environmental conditions must be within those specified in the 

product datasheet that can be found at http://www.proxim.com/products/wifi/ap/.  To most easily comply with these 
specifications, Proxim recommends mounting the AP-4900M in the passenger compartment of a vehicle or in a 
weatherproof NEMA box outdoors.

• When the AP is mounted within a vehicle, the metallic skin of the vehicle will retard the RF propagation of the AP. 
• Proxim recommends the 1086-PGTL adapter with an external vehicular antenna. For more information,, see 

. 

• The AP-4900M uses 5 V, not 12 V power. Therefore a 12V-to-5V transformer will be needed when mounting the AP in 

a vehicle.