Premier Mounts Modem CDM-600 사용자 설명서

다운로드
페이지 250
8–1 
Chapter 8. OFFSET QPSK 
OPERATION 
 
Offset QPSK modulation is a variation of normal QPSK, which is offered in the CDM-
600. Normal, bandlimited, QPSK produces an RF signal envelope that necessarily goes 
through a point of zero amplitude when the modulator transitions through non-adjacent 
phase states. This is not considered to be a problem in most communication systems, as 
long as the entire signal processing chain is linear.  
 
However, when bandlimited QPSK is passed through a non-linearity (for instance, a 
saturated power amplifier), there is a tendency for the carefully-filtered spectrum to 
degrade. This phenomenon is termed ‘spectral re-growth’, and at the extreme (hard 
limiting) the original, unfiltered sin(x)/x spectrum would result. In most systems, this 
would cause an unacceptable level of interference to adjacent carriers, and would cause 
degradation of the BER performance of the corresponding demodulator. 
 
To overcome the problem of the envelope collapsing to a point of zero amplitude, Offset 
QPSK places a delay between I and Q channels of exactly 1/2 symbol. Now the 
modulator cannot transition through zero when faced with non-adjacent phase states. The 
result is that there is far less variation in the envelope of the signal, and non-linearities do 
not cause the same level of degradation.  
 
The demodulator must re-align the I and Q symbol streams before the process of carrier 
recovery can take place. For various reasons this makes the process of  acquisition more 
difficult.