Pioneer PNR 14-150 사용자 설명서
12
© 2006 Pioneer Supply International
12
© 2006 Pioneer Supply International
© 2006 Pioneer Supply International
13
Figure 6
Figure 8
!
Figure 7
3 Using a straightedge as a guide and the set screws
for leveling control, position the extension wings
even with the table, then fully tighten the hex bolts.
even with the table, then fully tighten the hex bolts.
NOTE: Be aware that the bed rollers will give you a
false reading with your straightedge if they are raised
above the table. Move them down or work around them
when leveling the extension wings.
false reading with your straightedge if they are raised
above the table. Move them down or work around them
when leveling the extension wings.
Hand Wheel
You will need:
Hand wheel, Hand wheel Bushing, Hand wheel Handle,
Hex Nut, Flat Washer
Hand wheel, Hand wheel Bushing, Hand wheel Handle,
Hex Nut, Flat Washer
To install the Hand wheel:
1 Place the bushing on the Hand wheel shaft.
2 Insert the key into the shaft keyway.
3 Screw the handle into the Hand wheel.
4 Place the Hand wheel on the shaft and secure it with
1 Place the bushing on the Hand wheel shaft.
2 Insert the key into the shaft keyway.
3 Screw the handle into the Hand wheel.
4 Place the Hand wheel on the shaft and secure it with
the hex nut and flat washer, as shown in Figure 7.
Dust Hood
IMPORTANT: If you are not using a dust
collection system, do not use plastic dust
hood to direct chips. We reccomend to
always use a dust collector when operating
this planer.
collection system, do not use plastic dust
hood to direct chips. We reccomend to
always use a dust collector when operating
this planer.
You will need:
Dust Hood, 3 x Hex Bolts, 3 x Cap Screws, 6 x Flat
Washers, 3 x Hex Nuts, 6 x Flange Bolts
Dust Hood, 3 x Hex Bolts, 3 x Cap Screws, 6 x Flat
Washers, 3 x Hex Nuts, 6 x Flange Bolts
To install the dust hood:
1 Attach the dust hood to the top of the planer with
1 Attach the dust hood to the top of the planer with
the hex bolts, flat washers, and hex nuts as shown
in Figure 8. NOTE: You will need to reach into the
dust hood to get access for fastening the nuts.
in Figure 8. NOTE: You will need to reach into the
dust hood to get access for fastening the nuts.
2 Attach the bottom of the dust hood to the planer
with the cap screws.
3 If you have a dust collector, attach it to the dust
hood now. NOTE: To maximize work results and
minimize clogging, chip out, etc., use a dust
collector with your planer.
minimize clogging, chip out, etc., use a dust
collector with your planer.