Pelco Matrix Switcher/Controller CM6800E-48X8 사용자 설명서

C1528M-F (6/05)

13

Figure 4.  Installing Rack Ears

3.

Use supplied pan head screws and washers to mount the CM6800E in a standard 19-inch (48.26 cm) equipment rack or wood or
sheet metal screws to mount against a flat surface, according to your installation requirements.

Figure 5.  Mounting the CM6800E Matrix Switcher/Controller

POSITION BRACKETS FOR
RACK MOUNTING (FRONT)

POSITION BRACKETS FOR
FLUSH MOUNTING
(WALL AND TABLE TOP)

POSITION BRACKETS FOR
RACK MOUNTING (REAR)

NOTE: EACH CM6800 COMES
WITH 2 RACK EARS

POSITION BRACKETS FOR
UNDER-TABLE MOUNTING

Unpack and inspect all parts carefully. The following parts are supplied:

1

CM6800E Switcher/Controller

4

10-32 x .750-inch pan head screws

4

.500” OD nylon washers

1

Power cord

4

6-foot (1.8 m) straight data cables with RJ-45 connectors

1

6-foot (1.8 m) reversed data cable with RJ-45 connectors

4

RJ-45 wall block terminals

NOTE:  There are no user-serviceable parts inside this unit. Only authorized service personnel may open the unit.

1.

Select a suitable location for the CM6800E. It occupies 5.25 inches (13.34 cm) of vertical space, or three rack units (RUs), in a
universal mount. The CM6800E must be within 6 feet (1.8 m) of a suitable electrical outlet.

2.

The CM6800E is shipped with the rack ears installed at the front. Reposition or remove ears as needed for your application.