Texas Instruments Serial Programming Adapter MSP430 사용자 설명서
www.ti.com
MSP-TS430L092 Active Cable
shows the PCB layout for the Active Cable. The following pinning is possible:
•
JP1 has two jumpers (Jumper 1 and Jumper 2) that can be set as shown in
Table B-3. MSP-TS430L092 JP1 Settings
Jumper 1
Jumper 2
Description
Off
Off
The active cable has no power and does not function.
The active cable receives power from target socket. For this option, the
Off
On
target socket must have its own power supply.
On
Off
The active cable receives power from the JTAG connector.
The JTAG connector powers the active cable and the target socket. For
On
On
this option, the target socket must not have its own power source, as this
would cause a not defined state.
would cause a not defined state.
•
JP2 is for reset. For the standard MSP-TS430L092, this jumper must be set. It sets the reset pin to
high and can also control it. Without this jumper on the MSP-TS430L092, reset is set to zero.
high and can also control it. Without this jumper on the MSP-TS430L092, reset is set to zero.
Figure B-6. MSP-TS430L092 Active Cable Target Socket Module, PCB
41
SLAU278F – May 2009 – Revised December 2010
Hardware
© 2009–2010, Texas Instruments Incorporated