Technicolor - Thomson ST516V6 사용자 설명서

E-DOC-CTC-20060911-0017 v2.0

Chapter 2

If you want to make the required connections yourself without using the guided installation procedure as 
recommended, you must:

Read the safety instructions and regulatory notices first.

Follow the order as indicated below.

Use the grey DSL cable to connect the Thomson Gateway DSL port to your telephone wall outlet or 
distributed filter.

Plug the coaxial jack of the electric power supply adapter into the Thomson Gateway power inlet port and the 
other end into the wall outlet.

To turn on the Thomson Gateway, press the power button on the Thomson Gateway rear panel.

During the start-up procedure, the power LED on the front panel is lit red for some seconds. As soon as the 
power LED is solidly lit green, your Thomson Gateway is ready for service. After another couple of seconds, 
also the DSL LED will light green.

If these LEDs do not light, please refer to 

. A comprehensive LED overview 

can be found in the User’s Guide.

Use the same button to turn off your Thomson Gateway.

Your Thomson Gateway allows you to connect your computer via 

Ethernet

i

You can find the safety instructions on the Setup CD (see 

). They may also be provided as a printed booklet.

i

The Thomson Gateway electrical power requirements are indicated on the label on the bottom side 
of your Thomson Gateway. In case you need to use another power supply than the one provided, 
make sure that the spare supply complies with the Thomson Gateway power requirements.