Tandberg Data 2U LTO 사용자 설명서

Page 5 of 8

1 — Apply bar code labels to cartridges.
2 — Press the eject button to unlock the 
 

magazine (magazine releases and 

 

moves a short distance out of the 

 

library). This may take a few minutes.

3 — Pull the magazine straight out of the 
 

library (no side-to-side or up/down 

 

motion).

4 — Load cartridges in slots as shown.

 The last two slots in each magazine 

are blocked.
5 — Slide the loaded magazine back into 
 

the library. The library performs an 

 

inventory after the magazine is installed. 

 Refer to the Product Manual for 

important information about the cleaning 
slot location and the I/E port.

1 — Download and install LibTool and LTOTool onto 

your Host (select the version for your operating 
system). Available at www.tandbergdata.com.

2 — Use LibTool to: 
 

• Detect the library  
• View the library’s cartridge inventory

 

• Move tapes into and out of the tape drive 

3 — Use LTOTool to: 

a. Detect the tape drive

 

b. Perform a Read/Write test

 The readme files that accompany LibTool and  

LTOTool provide instructions.

EJECT

BAR CODE LABEL

CARTRIDGE

BAR CODE LABEL

ENTRY/EXIT PORT

Congratulations! You have successfully installed your new library! We recommend that you follow these steps:
1 — Read Exabyte’s Basic Backup Guide, which is available at: www.tandbergdata.com. 
2 — Select and install a backup application. Software compatibility information is available at: www.tandbergdata.com.
3 — Perform a backup. For questions regarding software installation, configuration, or operation (including how to 
 

perform a backup) — contact your software provider. 

 1) Driver installation may not be necessary and depends on the backup application that you use in your 

 

   system. Refer to the installation instructions for your backup application for verification.

 

   2) You can configure the library for a customized operation to fit your particular needs. 

 

   See the Product Manual at www.tandbergdata.com.