TANDBERG 8000 MXP 사용자 설명서

Installation 

11 

 

 
Unpacking the System 
 
To avoid damage to the unit during transportation the system is delivered as separate 
components: 

ƒ Base 
ƒ Monitor 

Frame 

ƒ Two 

Plasma 

Monitors 

 
Together with the Base you will find the monitor connector units, the monitor rear covers and the 
accessories box which will contain the following: 

ƒ W.A.V.E. 

II 

Camera 

ƒ Three 

Table 

Microphones 

ƒ  Remote Control and Tracker with batteries 
ƒ Cables 
ƒ Documentation 

 
Unpacking the Base 
 
Due to the weight of the system, the base should be placed in its permanent location as soon as 
it is unpacked. 
 
Unpacking and Installing the Monitor Frame 
 
Lift the monitor frame out of the box. Do not remove the straps or packaging that are around the 
rack. Place the rack on top of the base. Make sure that the cables from the base do not get stuck 
in between. You will find 4 bolts sticking out at the rear end of the base. Use the 4 nuts to fasten 
the monitor frame in place. You can now remove the straps and packaging from the monitor 
frame. 
 
IMPORTANT: Put your fingers in the holes on the side of the plastic cover and carefully flip down 
the plastic cover. Two persons should carry out this operation to avoid too much stress on the 
plastic cover. 4 hexagonal-shaped screws should be used to secure the monitor frame to the top 
of the Base. There are 2 holes 
located on each side. The front cover is made of plastic and should be treated with care. 
 
Installing the monitor(s) 
 
We recommend that there are 3 people present when installing the monitor(s): 

ƒ  Remove the plastic plugs located on the back of the monitor(s). Check to see where the 

holes in the monitor frame are located. 

ƒ  Take the monitor(s) and place it (them) inside the monitor frame. 
ƒ  Secure each monitor with the 8mm hexagonal-shaped screws. 
ƒ  Remove the protective plastic film from the monitor front. 
ƒ  The monitor connector units should be mounted at the rear of each monitor. Please see 

the instruction that comes with the connector (video) unit for correct installation.