Omron SYSMAC C200HW-ZW3AT2-E-V2 사용자 설명서

2) Executing “Initialize table” makes the model information for all nodes un-

specified (blank).

1. Select “I: Device Info set” from the Data Link Menu.

2. Select the node for which model is to be specified. Use the Cursor Keys to

move the cursor to the target node, then press the Enter Key or the F6 (Se-
lect) Key.

Press the F7 (Fill) Key to select all nodes.

Press the F3 (Delete) Key or the Delete Key to delete the model information
for the node in the cursor position.

Note a) If “Others” is selected, restrictions for each model will no longer

apply. Regardless of the model, restrictions will apply to only the
upper limits when numeric values are entered or checked.

b) New PCs that do not appear in the model list can be displayed and

selected from Controller Link Support Software by editing the de-
vice information setting file (see Appendix E Editing the Device In-
formation Setting File).

c) The version of the Controller Link Support Software is displayed

on the logo screen when the software is started.

3. Select the model to be set. Use the Cursor Keys to move the cursor to the

model to be set, then press the Enter Key. The specified model will be set for
the specified node. (Press the F7 Key to set the specified model for all the
nodes.)

4. After specifying the models for all the nodes, press the F10 (End) Key. The

model setting procedure will end.