Q-Logic Computer Drive IB0056101-00 G 사용자 설명서
3 – Step-by-Step Installation Checklist
Software Installation
Software Installation
3-2
IB0056101-00 G
S
Software Installation
The following steps summarize the basic InfiniPath and OpenFabrics software
installation and startup. These steps must be performed on each node in the
cluster:
installation and startup. These steps must be performed on each node in the
cluster:
1.
Make sure that the HCA hardware installation has been completed
according to the instructions in
according to the instructions in
2.
Verify that the Linux kernel software is installed on each node in the cluster.
The required kernels and supported Linux distributions for both InfiniPath
and OpenFabrics are defined in
The required kernels and supported Linux distributions for both InfiniPath
and OpenFabrics are defined in
3.
Make sure that your environment has been set up as described in
4.
Download your version of the InfiniPath/OpenFabrics software from the
QLogic web site to a local server directory. See
QLogic web site to a local server directory. See
5.
Unpack the tar file and check for any missing files or RPMs. See
6.
Install the appropriate packages on each cluster node as described in
. Also see
for a list of RPMs to install.
7.
Under the following circumstances, the system needs to be rebooted:
If this is the first InfiniPath installation OR
If you have installed VNIC with the OpenFabrics RPM set
The system can be rebooted after all the software has been installed. If you
are only upgrading from a prior InfiniPath software installation, drivers can
be restarted manually. See
are only upgrading from a prior InfiniPath software installation, drivers can
be restarted manually. See
.
8.
If you want to use the optional InfiniPath (ipath_ether) and OpenFabrics
drivers (ipoib) and services (opensm, srp), configure them as described in
drivers (ipoib) and services (opensm, srp), configure them as described in
9.
Check the system state by observing the LEDs. See
NOTE: