Q-Logic Computer Drive IB0056101-00 G 사용자 설명서

5 – Software Installation
Starting the InfiniPath Service

5-10

IB0056101-00  G

S

Other OFED-installed modules may also be in this directory; these are also 
renamed if found during the install process.

If this is the initial installation of InfiniPath (see 

), or if you have installed VNIC with the 

OpenFabrics RPM set, reboot after installing. 

If this is an upgrade, you can restart the InfiniPath service without rebooting. To 
enable the driver, run the command (as root):

# chkconfig infinipath on 2345

Then start the InfiniPath support (as root) by typing:

# /etc/init.d/infinipath start

Complete information about starting, stopping, and restarting the services are in 

.

When all of the InfiniPath and OpenFabrics software has been installed correctly, 
the default settings at startup are as follows:

„

InfiniPath 

ib_ipath

 is enabled.

„

InfiniPath 

ipath_ether

 is not running until it is configured. See 

 for configuration 

instructions.

„

OpenFabrics IPoIB is not running until it is configured. Once enabled, IPoIB 
is running in connected mode. See 

 for configuration instructions.

„

OFED SRP is not running until the module is loaded and the SRP devices 
on the fabric have been discovered.

„

VNIC is not running until it is configured.

„

OpenSM is enabled on startup. Either install it on only one node, or disable it 
on all nodes except where it will be used as an SM. 

Other optional drivers can now be configured and enabled, as described in 

,