Nuvo Home Theater System NV-E6D-UK 사용자 설명서

V. Connecting the EZ Port to the Essentia amplifier
When the EZ Port is installed in the wall the only part visible 
should be the faceplate, speaker connections for zones 1-6,  and 
a single RJ45 jack. The speaker connections are made using the 
supplied Euro connectors and the supplied pre-terminated 
network cable is used to integrate the system keypads. Speaker 
connections and the network connection are made from the face 
of the EZ Port the back of the Essentia, fig. 4.  Any CAT5 cable 
terminated using 568A or 568B network wiring will suffice should 
you need a longer network connection.

SYS ON

EXT. MUTE

VI. Attaching Audio Source Equipment to the Essentia Amplifier
Each piece of audio source equipment is connected to the 
Essentia amplifier with standard stereo RCA cables. Attach the 
RCA cable to the corresponding audio output on the source 
equipment and to the desired source input on the back of the 
Essentia amplifier, Fig. 5.

1

2

3

4

5

6

1

2

3

4

5

6

VII. Connecting the IR Emitters
IR commands for the source equipment are transferred from the 
Essentia amplifier to the source equipment via mini IR mouse 
emitters. Six of these are supplied with your Essentia System.  
The emitter is plugged into the corresponding source IR output 
on the Essentia and then placed over the IR receiver window on 
the source component, fig. 6. The IR outputs are individually 
routed to sources 1-6 allowing IR commands from the chosen 
source to only control that source.

The two SUM outputs will flash any IR command that is sent from 
any of the zones. This is used to connect the NuVo T2 Tuner, 
which has a single IR direct input to control both tuners to the 
Essentia System or an IR blaster designed to flash IR commands 
to a variety of components. This is done by plugging a single 
mono 1/8” patch cable into the SUM IR output and into the Direct 
IR input.