Nuvo Home Theater System NV-E6D-UK 사용자 설명서
*********************************************************************************
COMMAND:
COMMAND:
*ZxxMTOFF<CR> zone xx MUTE OFF (returns zone output to currently connected source at previous volume
setting).
RESPONSE:
RESPONSE:
Same response as for *ZxxCONSR<CR>
*********************************************************************************
COMMAND:
COMMAND:
*ZxxBASSyyy<CR> zone xx BASS EQ with yyy = EQ level, dB, 12 to +0 (flat) to +12 in 2 dB increments.
USE LEAD “0” IN TENS PLACE FOR VALUE LESS THAN 10.
RESPONSE:
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will override the non-volatile BASS setting (set from keypad) for this zone until power
is cycled.
is cycled.
*********************************************************************************
COMMAND: *ZxxTREByyy<CR> zone xx TREBLE EQ with yyy = EQ level, dB, 12 to +0 (flat) to +12 in 2 dB increments.
USE LEAD “0” IN TENS PLACE FOR VALUE LESS THAN 10.
RESPONSE:
COMMAND: *ZxxTREByyy<CR> zone xx TREBLE EQ with yyy = EQ level, dB, 12 to +0 (flat) to +12 in 2 dB increments.
USE LEAD “0” IN TENS PLACE FOR VALUE LESS THAN 10.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will override the non-volatile TREBLE setting (set from keypad) for this zone until
power is cycled.
power is cycled.
*********************************************************************************
COMMAND:
COMMAND:
*ZxxGRPON<CR> zone xx SOURCE GROUP ON.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will override the non-volatile GROUP setting (set from keypad) for this zone until
power is cycled.
power is cycled.
*********************************************************************************
COMMAND:
COMMAND:
*ZxxGRPOFF<CR> zone xx SOURCE GROUP OFF.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the will override the non-volatile GROUP setting (set from keypad) for this zone until power is
cycled.
cycled.
*********************************************************************************
COMMAND: *
COMMAND: *
ZxxVRSTON<CR> zone xx VOLUME RESET ON.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP
switches) for this zone until power is cycled.
switches) for this zone until power is cycled.
*********************************************************************************
COMMAND: *
COMMAND: *
ZxxVRSTOFF<CR> zone xx VOLUME RESET OFF.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP
switches) for this zone until power is cycled.
switches) for this zone until power is cycled.
*********************************************************************************
COMMAND: *
COMMAND: *
ZxxLKON<CR> zone xx KEYPAD LOCK ON This will INHIBIT ANY keypad control input on the zone. This is
the same as activating the Parental lock control at a keypad by holding down a SOURCE key for three
seconds).
RESPONSE: #
seconds).
RESPONSE: #
ZxxLKON<CR>6
27