Nokia Ethernet bridge adapters E66210.32 10/100BASE-T 사용자 설명서
Hardware installation instructions
DN0610789
© Nokia Corporation
11 (14)
Pin Signal Direction
1 Rx+ input
2 Rx- input
3 Tx+ output
4 Not
connected
5 Not
connected
6 Tx- output
7 Not
connected
8 Not
connected
Figure 10.
Ethernet connector and pin numbering
2.2 Cabling
ET-adapter is connected to the network adapter with a direct Ethernet cable.
The maximum length of a category 5 cable is 100m. If the ET-adapter is
connected to the Ethernet hub or switch then use a cross-connected Ethernet
cable.
The maximum length of a category 5 cable is 100m. If the ET-adapter is
connected to the Ethernet hub or switch then use a cross-connected Ethernet
cable.
Figure 11.
Direct cabling
Ensure that the Ethernet port that is connected to ET-adapter has the same
configuration as the ET-adapter. Port speed and duplex status have to be the
same at both Ethernet ports. It is not recommended to use auto-negotiation
option. Port configuration should always be fixed.
configuration as the ET-adapter. Port speed and duplex status have to be the
same at both Ethernet ports. It is not recommended to use auto-negotiation
option. Port configuration should always be fixed.