Netgear LG2200D 사용자 가이드

Select ADVANCED > Setup > LAN Setup.

In the IP Address field, type the IP address.

In the IP Subnet Mask, type the subnet mask of the router. 

The IP address and subnet mask identifies which addresses are local to a specific device 
and which must be reached through a gateway or router.

Change the RIP settings.

Router Information Protocol (RIP) allows a router to exchange routing information with 
other routers. 

a. In the RIP Direction list, select one of the following:

Both. The router broadcasts its routing table periodically and incorporates 

information that it receives.

Out Only. The router broadcasts its routing table periodically. 

In Only. The router incorporates the RIP information that it receives.

b. In the RIP Version list, select one of the following:

Disabled. This is the default setting. 

RIP-1. This format is universally supported. It is adequate for most networks, 

unless you have an unusual network setup. 

RIP-2. This format carries more information. Both RIP-2B and RIP-2M send the 

routing data in RIP-2 format. RIP-2B uses subnet broadcasting. RIP-2M uses 
multicasting.

Click the Apply button.

Your changes are saved.

If you changed the LAN IP address of the router, you are disconnected when this change 
takes effect.

To reconnect, close your browser, relaunch it, and log in to the router