Navigon MN 6 사용자 설명서

User's Manual MobileNavigator|6 

Navigation 

- 25 -  

Fixing the GPS receiver and its connection with your mobile 
telephone is described in chapter "Connecting the GPS receiver" 

on page10. 

 

Note: It can take up to 20 minutes to initialise the GPS receiver 

for the first time. 
Each time you switch on the receiver after this the GPS reception 

will start within half a minute. 
If the GPS receiver hasn’t been switched on for over a week, the 
next initialisation can take up to 10 minutes. 

 

The GPS starts initialises as soon as the GPS receiver is switched 

on. 
If your GPS receiver is connected to the mobile telephone, in the 

upper right corner of the display you will see the GPS icon. It can 
show three different states: 

 
 

 

No GPS receiver is connected to the 
mobile telephone  

OR  
the GPS receiver is switched off. 

 

The data is being received from less than 
three satellites. The position cannot be 
calculated. 

 

The data is being received from at least 3 
satellites. The position can be calculated. 

 

Within 15 seconds the GPS icon changes from No GPS to No 
Signal. 
As soon as data is being received from at least 3 satellites, the 
GPS icon changes to GPS ready. 

Note: The first initialisation can take up to 20 minutes. 
If the GPS icon shows the status GPS ready after considerably 

less than 20 minutes, then it is best to switch off the receiver for 
at least 15 minutes so as to guarantee a reliable operation of the 
receiver. 

Attention: If you have connected the GPS receiver to the power 

supply via a cigarette lighter, then remove the connector before 
you leave the vehicle standing for a long period of time. 
The GPS receiver needs power constantly so it could run down 
the vehicle’s battery.  

Refer to the GPS receiver user manual for detailed information 
regarding the functioning and the power supply of the GPS 

receiver.