Kramer Electronics Musical Instrument Revision 6 사용자 설명서
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the RC-6X Series Room Controller as a Standalone Device
86
Figure 179: Load Firmware Upgrade Window
8. Click Start Upgrade.
9. Upon completion, open the Device Settings Tab to make sure the firmware was upgraded
9. Upon completion, open the Device Settings Tab to make sure the firmware was upgraded
10.3 The Help Menu
Figure 180: The Help Menu
Table 18: Help Menu Features
Menu Command
Function
Check for updates
Check on the Kramer Electronics Web site for software
updates.
About Kramer K-Config Shows the current software version.
11 Connecting the RC-6X Series Room Controller as a Standalone Device
You can configure the Room Controller to be used as a standalone device. To do this you have to
connect the Room controller directly to your PC via the USB connector.
To define an RC-6X as a Master device:
1. From the Device Menu, click Connect….
2. Select the connection method to be USB, select the port and click OK.
To define an RC-6X as a Master device:
1. From the Device Menu, click Connect….
2. Select the connection method to be USB, select the port and click OK.
The following warning appears:
Figure 181: Transforming to the Standalone Configuration
3. Click Yes.
When in the standalone mode, you can write the actions directly to RC-6X by clicking the Write
When in the standalone mode, you can write the actions directly to RC-6X by clicking the Write
Configuration button.
To exit the standalone mode open the Device menu and select Set as Aux.
To exit the standalone mode open the Device menu and select Set as Aux.
1
If the firmware number remains the same, close the Device Properties windows, disconnect and then reconnect the device, and open the Device Properties
window again to check the Firmware number