Kärcher 600 MP 사용자 설명서
WTC 600 LP / MP
5
Maintenance and Care
Version 06/05
3.1.3
Switching On the Equipment
• Check if the pumps of the metering station,
sand and activated carbon filter are connected
to the respective power outlets (18 / 19) at the
switch box (8).
to the respective power outlets (18 / 19) at the
switch box (8).
• Check if the operating mode switch (9) is in the
correct position “Automatic” or “Hand”.
• Switch the main switch (20) to the “I” position;
the system starts the drinking water produc-
tion.
tion.
3.1.4
Operating Indicators
• Display of the time
• LED line: Display of the weekday
Control of the RO system:
The following is alternately indicated on the
two-line display of the control panel (10) of the RO
system:
two-line display of the control panel (10) of the RO
system:
• Equipment/model No. and operating condition,
• Drinking water temperature and drinking water
conductance value,
• Operating hours (_ _ _ _ _h _ _min).
If the metering container was com-
pletely empty, the metering pump (29)
may have possibly drawn in air. In this
case, bleed the air from the pump as
described in Section 3.2.3.
pletely empty, the metering pump (29)
may have possibly drawn in air. In this
case, bleed the air from the pump as
described in Section 3.2.3.
i
In the “Automatic” operating mode, the
system is controlled via an external float
switch in the drinking water tank.
system is controlled via an external float
switch in the drinking water tank.
In the “Hand” operating mode, the sys-
tem is switched on and off manually via
the main switch.
tem is switched on and off manually via
the main switch.