MRV Communications EM316EDFA-BR 사용자 설명서

 

 

®

 

 
P/N 1294008-001 Rev D2 

 

11 

 
 
 

 
The EM316LNXNM-OT provides command line interface (CLI), SNMP, and graphical 
administration options for a Fiber Driver chassis system. This section introduces the CLI for the 
Linux-based network management (EM316LNXNM-OT) module. 
 
EM316LNXNM-OT management commands are specific to each module. 
 
The EM316LNXNM-OT management module also includes MegaVisionJ, a built-in graphical 
interface to manage only the Fiber Driver chassis system controlled by the specified NM. This 
graphical system is accessible from any standard Java-enabled web browser that can reach the IP 
address assigned to the EM316LNXNM-OT. MegaVisionJ allows remote management of the entire 
Fiber Driver chassis system and compatible modules. 
 
 
Some commands applicable to the EDFA amplifier modules or host chassis are illustrated in this 
manual. The box below lists a few of the sample commands addressed in this document. Refer to 
the Table of Contents for a list of commands addressed here, and refer to EM316LNXNM-OT 
documents for more detail. 
 

show 
? 
list 

show config 
show defaults 
description <name> 

Figure 7   -- EM316LNXNM-OT general commands for EDFA modules 

 
 
Some of these commands apply to both slot-level and port-level contexts as described in the 
navigation portion of this section. Refer to EM316LNXNM-OT documentation for a more complete 
discussion of the Linux-based interface and available commands.