Milan Technology MIL-140TRM 사용자 설명서

 

Installation Guide: MIL-140TRM

6

3

 

There are four LEDs, including:

•

 

: Receiving packets from the 10BASE-T port

•

 

: There is an active connection on the 

10BASE-T port

•

 

: There is an active connection on the 

10BASE-FL port

•

 

: Receiving packets from the 10BASE-FL port

 

• Pin 1 = Transmit Data + 

• Pin 2 = Transmit Data -

• Pin 3 = Receive Data +

• Pin 6 = Receive Data -

 

• Pin 1 = Receive Data + 

• Pin 2 = Receive Data -

• Pin 3 = Transmit Data +

• Pin 6 = Transmit Data -

 

Do the following to install the MIL-140 into a rack 
mount chassis:

1. Make any configuration changes to the module (i.e., 

DIP switch settings).

2. Remove the screws securing the faceplate and 

remove it from the chassis.

3. Slide the module into the slot through the guide 

rails.

4. Insert the module into the card-edge connector (port 

bay). Make sure it is seated firmly.

5. Secure the module with the two thumbscrews 

located on the faceplate of the unit.

The unit is now ready for network connections.

 

The MDI-X/MDI switch allows for quick configuration 
of the 10BASE-T port. Cables used when the switch is in 
the MDI-X position (the “left” position):

• For a hub/repeater, use a swap cable (pins are 

connected 1 to 3, 2 to 6, 3 to 1, and 6 to 2)

• For a workstation/PC, use a straight-through cable 

(pins are connected 1 to 1, 2 to 2, 3 to 3, and 6 to 6)