MegaTech Whirlwind 3000 사용자 설명서

3

SAFETY PRECAUTIONS

• Since your Whirlwind 3000 is controlled by an optical link it is very important to always use fresh 

alkaline batteries in the transmitter. When the red LED light becomes dark, flashes or does not glow 
on the transmitter, immediately install fresh batteries. Failure to do so could result in the loss of 
control and (most likely) a crash.

• Never mix old and new batteries. Do not mix Alkaline, standard Carbon-Zinc or rechargeable 

(Nickel-Cadmium, Nickel-Metal Hydride or Lithium).

• Always remove batteries from the transmitter when you have finished flying for the day. Do not 

store batteries inside the transmitter.

•   Extreme care must be taken in handling the Whirlwind 3000. Do not crush, step or sit on your Whirlwind 

3000.

•   Although the rotor and tail blades on the Whirlwind 3000 are very small and flexible they should still be 

treated with respect and caution! Use care when operating your Whirlwind 3000. Keep your hands, fingers 
and any article of clothing away from the spinning rotor and tail blades. 

•   Always fly your Whirlwind 3000 in a wide-open room. Make sure that the flight area is free from 

obstructions. Your Whirlwind 3000 is extremely lightweight and obstacles can damage the helicopter or 
cause it to crash.

•   Do not fly around people who are unaware that you are flying a Whirlwind 3000, and never fly over 

peoples heads. Keep spectators behind you when flying.

•   Do not attempt to disassemble any of the Whirlwind 3000’s components or allow them to get wet or 

electrical damage may occur. If the Whirlwind 3000 ever comes in contact with any moisture, dry it 
carefully and allow it to stand overnight before attempting to use it again.

•   Never use solvents or liquid cleaners to clean the Whirlwind 3000, doing so may damage the unit or it’s 

electronics. Only use a dry, soft cloth for cleaning the Whirlwind 3000.

•   Your Whirlwind 3000 is intended for indoor flight ONLY as it flies slowly and is capable of turning within 

the confines of an average sized living or dining room. 

•   Your Whirlwind 3000 is extremely lightweight and breezes from fans, air conditioning or even a person 

walking by can affect its performance.

•   You must point your controller at the Whirlwind 3000 at all times to maintain accurate control.
•   Natural daylight (not light bulb/indoor lighting) can affect the range and controllability of the Whirlwind 

3000.

•   Keep the Whirlwind 3000 away from heat or fire. Never leave the Whirlwind 3000 or transmitter in direct 

sunlight for any length of time

• The Lithium Polymer battery is factory installed into your Whirlwind 3000 and provides superior 
performance, but has specific charging requirements different than that of other battery types such as 
NiCad, NiMH and other rechargeable batteries. Improper handling of Lithium Polymer batteries could 
result in the battery drastically overheating, so please follow all warnings and instructions.
• ALLOW INTERNAL FLIGHT PACK TO COOL FOR 10 MINUTES AFTER EACH FLIGHT BEFORE ATTEMPTING 
TO RECHARGE.
• Never leave the Whirlwind 3000 plugged into the charger when it is not in use. Damage to the on-
board battery can occur.
• See charging safety under the charging section on page 6 for additional warnings.