McDATA OPENconnectors Command Line Interace 사용자 설명서

configuration. A configuration backup file is required to restore 
configuration data if the CTP card in a nonredundant Intrepid 6064 is 
removed and replaced. 

Nondedicated link. Typically used to describe a link between nodes 
which allows the switch to forward Class 2 or Class 3 frames as 
resources (ports) allow. Contrast this to the dedicated bandwidth that 
is required in a Class 1 Fibre Channel Service point-to-point link.

See optical fiber connector.

Circuit card that contains the director microprocessor. The CTP card 
also initializes hardware components of the system after power-on. A 
10 Mbps RJ-45 twisted pair connector is located on the CTP card to 
connect to the Ethernet LAN and communicate with the EFC Server 
or a specific management station. 

A hardware unit that controls the reading, writing, or displaying of 
data at one or more input/output units.

See cyclic redundancy check.

See control processor card.

System of error checking performed at both the sending and 
receiving station using the value of a particular character generated 
by a cyclic algorithm. When the values generated at each station are 
identical, data integrity is confirmed.

See Class 3 Fibre Channel service.

Pertaining to an attribute, value, or option that is assumed when none 
is explicitly specified. 

Contains all attached devices that are not members of a separate 
zone.

Product, connected to a managed director, connected to a switch or 
director, that is not controlled by the switch or director’s management 
software. See also node.