Maxon Telecom WL7-VERS. C 사용자 설명서

 

28

11921 Slauson 

A

ve.  Santa Fe Springs, CA.  90670  (800) 227-41

16  F

AX (888) 771-7713

1.  Use template (FIG. 27-1) or the base plate on the 

Lift (FIG. 28-1, holes 1-10) to mark eight (8) to 
ten (10) 7/16” mounting holes through the vehicle 
fl oor. Before drilling holes in the vehicle fl oor, make 
sure no wires and fl uid lines are too close to hole 
locations. Drill holes 1, 2, 9, 3, and 4. 

NOTE: MAXON recommends using all 10 carriage screws (Kit items) to bolt Lift to 
            vehicle. A minimum of 8 screws or bolts and use of holes 1, 2, 3, 4 & 9 are 
            required for correct installation. Also, the 3 front holes should be selected to 
            give a symmetrical bolt pattern (i.e. holes 5,10, & 8 or holes 6,10, & 7).

3.  Temporarily secure Lift to vehicle with two mounting 

bolts (Kit items), inserted through base plate holes 1 
and 4, or holes 2 and 3 (FIG. 28-1). Use two lock 
nuts and correct under-vehicle supports (Kit items) to 
secure the Lift. Use instructions supplied with vehicle 
installation kit to select the correct bolts, nuts and sup-
ports. Alternately, tighten the two bolts and nuts to 20 
to 30 LBS.-FT.

NOTE: Vehicle fl oor must meet the requirements shown at the beginning of the        

VEHICLE REQUIREMENTS section in this Installation Manual.

2.  Position Lift so holes 1-10 in the base plate (FIG. 28-1) 

are aligned with the correct holes drilled in vehicle fl oor.